Drawers, inserts and shelves
These generators build on the finger-jointed box and are in Toolbox → Boxes and Furniture. All of them are assemblies: the 3D view shows them put together, and the tests behind them check that no parts overlap.
Drawer
A drawer with a carcass open at the front, a matching drawer box and a front panel. Without the carcass you get just the drawer box, for an opening that already exists.
| Field | Meaning |
|---|---|
| Width, Height, Depth | Outer size of the carcass. Without carcass: size of the opening. |
| Material thickness | Thickness of the board. |
| With carcass | Builds the carcass too. |
| Front panel | Overlay (covers the carcass), Inset (inside the opening) or None. |
| Handle | Hand slot or Round hole, with Handle width (slot length or hole diameter) and Handle height; or None. |
| Side clearance, Top clearance, Back clearance | Air between drawer box and carcass. |
| Gap around the front panel | The front panel is made this much smaller on every side. |
| Kerf | Width of the laser cut. |
Finger width and Fit clearance are under Advanced.
Divider insert
A grid of halved dividers that slot into each other, for a box or drawer: for screws, beads, tea bags or game pieces.
| Field | Meaning |
|---|---|
| Inner width / Inner depth | Inner size of the box or drawer the insert goes into. |
| Divider height | Height of the dividers. |
| Material thickness | Thickness of the board. |
| Compartments across / Compartments deep | Number of compartments in each direction. |
| Fit clearance | Slots are made this much wider than the material thickness; negative = press fit. |
| End clearance | Dividers are made this much shorter than the inner size so the insert drops in easily. |
| Kerf | Width of the laser cut. |
Slot-together shelf
Two sides and any number of shelves joined by cross slots: no glue, no screws.
| Field | Meaning |
|---|---|
| Width | Length of the shelves. |
| Depth, Height | Size of the sides. |
| Material thickness | Thickness of the board. 4 mm or more makes a stable shelf. |
| Number of shelves | 1 to 30. |
| Lowest shelf above floor | Height of the underside of the lowest shelf. |
| Top shelf below top edge | Distance from the top of the sides to the top face of the highest shelf. |
| Shelf overhang | How far the shelves stick out past the sides. |
| Fit clearance | Extra slot width; negative = press fit. |
| Kerf | Width of the laser cut. |
The shelves are evenly spaced between the lowest and the highest one.