Pulleys and cams
Both generators are in Toolbox → Mechanics.
Timing pulley
A Pulley for toothed belts, with the outside diameter calculated from the pitch and the pitch line offset of the belt.
| Field | Meaning |
|---|---|
| Belt profile | GT2 (2, 3 or 5 mm pitch) or HTD (3M, 5M). |
| Number of teeth | 8 to 400. |
| Groove clearance | Widens every groove so the belt runs in easily (negative values make it tighter). |
| Kerf | Width of the laser cut. |
| Bore | None, round, D-shaft or with keyway, as for gears. |
The grooves are round, with the usual groove depth and width for the profile. A belt pulley is usually cut from several layers glued together, with a larger disc on each side as a flange.
Disc cam
A Cam turns rotation into a lifting motion of a follower: for automata, toys and simple mechanisms. One revolution is split into rise, dwell at the top, return and dwell at the bottom.
| Field | Meaning |
|---|---|
| Base circle radius | Smallest radius of the cam: the follower is at its lowest here. |
| Lift | How far the follower rises. |
| Rise angle | Rotation over which the follower rises. |
| Dwell at top | Rotation over which it stays at the top. |
| Return angle | Rotation over which it falls again. The rest of the turn is the dwell at the bottom. |
| Motion law | Cycloidal (low jerk), 5th-degree polynomial or Harmonic. Cycloidal runs smoothest. |
| Follower | Roller (with Roller diameter) or Knife edge. |
| Kerf | Width of the laser cut. |
| Bore | As for gears. |
The dialog checks the pressure angle and the roller size: if the cam is too steep for the follower, or the roller too large for a hollow in the cam, a warning appears. A larger base circle or a longer rise angle helps.