Gears and racks
The gear generators make real involute teeth, generated the way a hob cuts them, with exact root fillets and undercut for small tooth counts. The outlines are Bézier curves within 0.004 mm of the true shape. Find them in Toolbox → Mechanics.
Gear
| Field | Meaning |
|---|---|
| Number of teeth | 5 to 400. |
| Module | Pitch diameter divided by the number of teeth. Meshing gears need the same module. The pitch diameter is module × teeth: 24 teeth at module 2 give 48 mm. |
| Pressure angle | 20° is common. Meshing gears need the same angle. |
| Backlash | Play of the gear pair on the pitch circle; each gear's teeth get thinner by half of it. |
| Kerf | Width of the laser cut; the outline is offset outward by half of it, the bore inward. |
| Bore | None, Round, D-shaft (flat) with the size across the flat, or With keyway with keyway width and depth. |
Under Advanced:
- Profile shift x: positive values make the tooth roots stronger and avoid undercut on small gears; the centre distance changes by x × module.
- Root fillet and Bottom clearance (× module): standard values are 0.38 and 0.25.
Backlash and kerf are separate on purpose: backlash makes room between the teeth of two gears, the kerf makes up for the material the laser removes.
Gear pair
Gear pair creates two matching gears at the right centre distance, as one assembly. In the 3D view they mesh and can turn.
| Field | Meaning |
|---|---|
| Teeth gear 1 / Teeth gear 2 | The ratio is teeth 2 ÷ teeth 1. |
| Module, Pressure angle, Backlash, Kerf | As for a single gear. |
| Base plate with axle holes | Adds a plate with both axle holes at the right distance, with Axle hole diameter and Base plate margin around the tip circles. |
| Bore | Per gear. |
Profile shift gear 1 (Advanced) shifts the small gear; gear 2 gets the opposite shift, so the centre distance stays the same.
Rack
A Rack is a straight gear that meshes with a spur gear: rotation becomes linear motion.
| Field | Meaning |
|---|---|
| Number of teeth | Length of the rack in teeth (the length is teeth × module × π). |
| Module, Pressure angle | Must match the gear. |
| Backlash | Split between rack and gear. |
| Backing height | Material below the tooth roots. |
| Kerf | As for the gear. |
Tips
- Plywood and acrylic from 3 mm work well from module 1.5 up. Smaller modules need a thin, precise beam.
- Cut a gear pair and test it on two pins before making a larger mechanism; adjust the backlash if it binds.
- Put a pin through the centre bore instead of relying on the bore of plywood alone: wood wears quickly.